Replacing the batteries in your Rally series pedals is a simple process. The battery in each pedal is a CR1/3N or 2L76 battery.
It is recommended you replace all batteries at the same time.
Do not mix battery types.
Tools Required:
- 4mm Hex Wrench
Steps to Replacing the Battery:
- Remove the battery cover located opposite the pedal shaft of the Garmin Rally pedal. You will need the 4mm hex wrench. Turn the wrench counter clockwise.
- Remove the battery.
- Allow 5 to 10 seconds and install the new battey into the cover. Make note of the battery position.
- Replace and hand tighten the battery cover. It is important not to lose or damage the o-ring gasket.
- Tighten the battery cover with the hex wrench to 3.6 lbf-ft. (5N-m). The pedal LED displays one short green flash followed by on long red flash upon connection.
Comments
Please sign in to leave a comment.