Probable Cause
- Defective Wire Harness or Wax Motor.
Corrective Action
- Cycle motor in waxer manual mode in diagnostics and verify 120VAC at the P6 connector on Wax/Lift PCB.
- If voltage exists, verify that the cable from the Wax/Lift PCB to the wax motor has continuity.
- If continuity exists, replace the wax motor.
- No continuity, replace the wire harness.
- If no voltage exists, replace the Wax/Lift PCB.
- If voltage exists, verify that the cable from the Wax/Lift PCB to the wax motor has continuity.
Comments
Please sign in to leave a comment.