FS 0 Error on StarTrac 1000 Treadmill

Probable Cause

Fail-Safe Tripped

  1. “ON/OFF” Power switch cycled too fast.
  2. Faulty motor control board.
  3. Faulty display cable.
  4. Attempting to run after executing watchdog trip in motor test mode.

Corrective Action

  1. Shut power switch "OFF" and wait ten seconds, then turn power switch "ON".
  2. Swap motor control board with a known good part. Replace the motor control board if necessary.
  3. Swap display cable with a known good part. Do not route the cable for testing purposes. Replace display cable if necessary.
  4. Shut power "OFF" and wait ten seconds, then turn power switch "ON".
Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

See more
Customer Service Hours:
8:00am - 5:00pm CST Monday to Friday