Console Codes for Stairmaster Crossrobics 1650LE, Test and Customize

Use console codes to test and diagnose problems with your Stairmaster Crossrobics 1650LE. You can also use console codes to customize your setup.

Console codes require the unit to be in an "idle" state for the code to be accepted. "Idle" state means the console is not displaying an error or any message that requires data input. The display should basically be freshly powered up, scrolling the EKG or welcome message.

Level ^, 30, ENTER Change workout time limit
Level ^, 31, ENTER Change units
Level ^, 32, ENTER Choose the type of heart rate input
Level ^, 34, ENTER Choose console language
Level ^, 35, ENTER Change contrast
Level ^, 39, ENTER Reset to factory defaults
Level ^, 40, ENTER Display machine run time in hours
Level ^, 41, ENTER Display number of workouts
Level ^, 42, ENTER Display distance traveled
Level ^, 43, ENTER Display software revision
Level ^, 44, ENTER Display machine type
Level ^, 46, ENTER Display machine run time in hours since last cleared (used for maintenance)
Level ^, 60, ENTER Test display
Level ^, 61, ENTER Test keyboard
Level ^, 62, ENTER Test serial port
Level ^, 63, ENTER Test alternator
Level ^, 66, ENTER Test tach signal
Level ^, 71 Reset service counter
Level ^, 80 Change Machine
Was this article helpful?
0 out of 0 found this helpful



Please sign in to leave a comment.

Articles in this section

See more
Customer Service Hours:
8:00am - 5:00pm CST Monday to Friday