Display Test Mode for StarTrac 1600 Treadmill

Testing the Display on a StarTrac (Unisen) 1600 Treadmill

  • To test the display circuit board, hold the "5" key down while switching the treadmill on.
  • All the lights on the display will stay lit until a key is pressed.
  • After pressing a key the display will then show the revision number of the software.
  • Pressing different keys, other than STOP will illuminate different patterns on the display.
  • Pressing STOP ends the display board test.

NOTE: If the above does not occur properly, there is an error with the display board.

Was this article helpful?
0 out of 0 found this helpful



Please sign in to leave a comment.

Articles in this section

See more
Customer Service Hours:
8:00am - 5:00pm CST Monday to Friday