Probable Cause
- Running belt movement was detected by the Opto (speed) sensor without the command of the motor controller to engage the belt.
Corrective Action
- Ensure the user is not pulling or pushing the belt manually prior to starting a workout.
Articles in this section
- Console Flashing Prompt on LifeFitness 90C and 90CW Bikes
- Notify Maintenance Motor Controller Error for LifeFitness Next Gen Treadmills
- Notify Maintenance Frame Tag Unplugged Error on LifeFitness Next Gen 9100, 9500 and 9700 Treadmills
- No AC Power Error on LifeFitness Next Gen 9100, 9500 and 9700 Treadmills
- Smart Stop Unplugged Error on LifeFitness TR9700HR and TR9500HR Treadmills
- Waxer Unplugged Error on LifeFitness 9700, 9100 and 9500 Next Gen Treadmills
- Waxer No AC Power Error on LifeFitness 9700, 9100 and 9500 Next Gen Treadmills
- Wax/Lift Comm Bad Error for LifeFitness 9700, 9100 and 9500 Next Gen Treadmills
- Unable to Obtain Target Speed Error on LifeFitness 9700, 9100 and 9500 Next Gen Treadmills
- System Configured Two Wired Error on LifeFitness 9700, 9100 and 9500 Next Gen Treadmills
Comments
Please sign in to leave a comment.