This covers the console codes for the Stairmaster FreeRunner 5600 elliptical. These codes are used to test the machine and customize the settings.
Console codes require the unit to be in an "idle" state for the code to be accepted. "Idle" state means the console is not displaying an error or any message that requires data input. The display should basically be freshly powered up, scrolling the EKG or welcome message.
| Level ^, 30, ENTER | Change workout time limit |
| Level ^, 31, ENTER | Change units |
| Level ^, 32, ENTER | Choose the type of heart rate input |
| Level ^, 34, ENTER | Choose console language |
| Level ^, 35, ENTER | Change contrast |
| Level ^, 39, ENTER | Reset to factory defaults |
| Level ^, 40, ENTER | Display machine run time in hours |
| Level ^, 41, ENTER | Display number of workouts |
| Level ^, 42, ENTER | Display distance traveled |
| Level ^, 43, ENTER | Display software revision |
| Level ^, 44, ENTER | Display machine type |
| Level ^, 46, ENTER | Display machine run time in hours since last cleared (used for maintenance) |
| Level ^, 60, ENTER | Test display |
| Level ^, 61, ENTER | Test keyboard |
| Level ^, 62, ENTER | Test serial port |
| Level ^, 63, ENTER | Test alternator |
| Level ^, 64, ENTER | Test continuous brake cycle |
| Level ^, 65, ENTER | Test brake on/off position |
| Level ^, 71 | Reset service counter |
| Level ^, 80, ENTER | Change Machine |
Comments
Please sign in to leave a comment.